Topic
Installation
Most performance complaints trace back to installation: undersized ducts, no path for air to leave, or a unit pulling hot roof air. Get these details right once and the cooler works as rated.
Start here
Swamp Cooler Installation Guide: How to Install a Roof, Wall or Window Evaporative CoolerTo install a swamp cooler, set the unit level on a solid roof stand, wall bracket or window frame, connect a duct or discharge into the house, run a cold water line to the float valve, route the bleed-off and drain, provide a dedicated electrical circuit and control, and open enough relief air for the house to exhaust.
All installation guides
- Ductwork for Evaporative Coolers: Drops, Duct Sizing, Diffusers and Insulation
How to size and lay out swamp cooler ductwork: roof jack and drop, main and branch duct sizes by CFM, diffusers, insulation, winter dampers and AC duct reuse.
- Venting and Relief Air for Swamp Coolers: How Much to Open, Where, and Why
How to vent a house with a swamp cooler: the 1 to 2 sq ft per 1,000 CFM rule, worked window math, ceiling relief dampers, attic venting and pressure symptoms.
- How to Install a Window Swamp Cooler (Evaporative Window Unit)
Install a window evaporative cooler safely: measuring the opening, support brackets, level and pitch, filler panels, water hookup, drain, power and relief air.
- How Much Does It Cost to Install a Swamp Cooler? 2026 Line-Item Price Guide
Typical 2026 swamp cooler installation costs by job type: rooftop swap, new install, side-draft, ducted and window units, with line items, labor and DIY tips.
- Do I Need a Permit to Install or Replace a Swamp Cooler?
Swamp cooler permit rules for Phoenix, Tucson, Pima County, Albuquerque, Las Vegas, Salt Lake, El Paso and Denver, and what ends a like-for-like exemption.
- What Size Breaker and Wire Does a Swamp Cooler Need?
Breaker and wire size for 1/3, 1/2, 3/4 and 1 hp swamp coolers at 120 V and 240 V, worked from NEC motor tables, Champion spec sheets and real nameplates.
- Does a Swamp Cooler Need GFCI Protection?
When a swamp cooler needs GFCI protection now the NEC's HVAC exception has expired, with the rule for AZ, NV, CA, CO, UT, NM and TX.
- How Much Does a Swamp Cooler Weigh on the Roof?
Shipping and operating weights for Champion, MasterCool and Breezair coolers from their spec sheets, the load per square foot, and why the roof figure is higher.
- What Size Generator Do You Need to Run a Swamp Cooler?
Running watts, starting watts and locked-rotor amps for 1/3 to 1 hp swamp coolers and Portacool portables, checked against a 2,200 W and a 3,000 W inverter generator.
- Can You Use an Extension Cord With a Swamp Cooler?
What gauge extension cord a portable swamp cooler needs: maker rules, amps for Hessaire, Honeywell and Portacool models, and voltage drop at 25, 50 and 100 ft.
- How Many Solar Panels Does It Take to Run a Swamp Cooler?
Panel watts for 1/3, 1/2 and 3/4 hp swamp coolers, Breezair and Portacool models at 6 and 10 hours a day, sized to August sun in nine Western cities, plus the inverter surge each motor needs.
- What Size Roof Jack Do You Need for a Swamp Cooler?
Duct opening sizes for Champion, MasterCool, Hessaire and Breezair coolers from their spec sheets, which roof jack each one takes, and why the box CFM picks the wrong jack.
- Can an HOA Ban a Swamp Cooler?
Which states stop an HOA from banning a swamp cooler: California's 2026 law, Colorado, Oregon's portable rule, and why Arizona, Nevada, New Mexico, Utah and Texas have none.
- Is a Landlord Required to Fix a Swamp Cooler?
When a landlord must fix a swamp cooler, how fast, and how cool it must get: Phoenix 86 F, Tempe 88 F, Albuquerque's rule, and AZ, NV, NM, UT, CO, CA law.
- Can You Use Swamp Cooler Ducts for Central Air Conditioning?
A swamp cooler drop is big enough for a 2 to 5 ton AC system, but it is half a duct system. The return, R-8 insulation, 4.0 CFM leakage limit and roof opening that have to change.
- Can You Put a Swamp Cooler on a Mobile Home?
HUD's rules for a roof-mounted cooler on a manufactured home, the 20, 30 and 40 psf roof load zones against real cooler weights, and Arizona's permit and license rules.
- How Far Does a Swamp Cooler Need to Be From a Plumbing Vent or Flue?
The code distance between a swamp cooler and a plumbing vent, water heater flue, dryer vent or street: 10 ft unless the vent ends 3 ft above the intake, with worked rooftop and window cases.